General; A.1 Introduction - AOIP CALYS 50 Mode D'emploi

CALYS 50 / 75 / 100
A. GENERAL
We are very grateful to you for choosing this AOIP S.A.S accuracy measuring instrument which benefits from our hundred
years' experience in the manufacture of high quality, accuracy measuring instruments.
Because of this, we are able to continue our policy of continuous innovation which has served our customers so well for
the last 100 years. AOIP S.A.S encourages your comments and would willingly accept any suggestions from you to help
us to perfect our know-how and improve our future products.

A.1 Introduction

The CALYS 50 / 75 / 100 is a multifunction calibrator. It is specially designed for calibration and maintenance and can
measure and simulate physical and electrical quantities, either on site or in the laboratory.
It can perform all the following functions:
Measure DC voltage and current, resistance and frequency/ counts and pressure.
Measure temperatures using thermocouples and resistive probes.
Supply power and measure a current loop which is compatible with the HART® protocol.
Generate DC voltages and currents.
Simulate resistance, thermocouples and resistive probes.
Recording of measurements and their display as a table or trend curve (function only available for models CALYS
75 and CALYS 100).
Calibration and generation of the calibration report (function only available for models CALYS 75 and CALYS
100).
Possibility of using calibrated sensors with memorization of the calibration factors
Measurement and transmission can take place simultaneously, with a double display.
The CALYS 50 / 75 / 100 has many associated functions that extend its range of application:
Relative measurement.
Results displayed based on a linear or other conversion law.
Generation of increments and simple or cyclic ramps.
Synthesis of curves.
88 / 164 NTA47227-300A8

GENERAL