Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
C
Simulation modes
C.1.4
Staircase mode
This mode is used to program an incremental progression of the active transmission function.
When this mode is active, the
icon appears in the transmission window.
The
function key launches a cycle of increasing increments and the
function key launches a cycle of
decreasing increments.
The default parameters of this mode are displayed on the left hand side of the transmission window. To change these
parameters, press ENTER or use the Configuration
Mode... menus.
The parameters of a staircase are:
B: minimum amplitude of the signal.
H: maximum amplitude of the signal.
I: amplitude of the increment
T: duration of the steps in seconds
Delay: delay in seconds between launching the staircase and transmission of the first increment.
NTA47227-300A8
131 / 164
Publicité
Chapitres
Table des Matières
