Getting Started; B.1 Powering-On; B.2 Measurement - AOIP CALYS 50 Mode D'emploi

CALYS 50 / 75 / 100
B. GETTING STARTED
In order to use the unit in complete safety, users must carefully read paragraph A.1 (page 20) which, among other things,
deals with safety before handling. It is advisable also to read the following paragraphs:
A.1.2 Unpacking
A.2.7 Battery and charger
A.6.3 Cleaning

B.1 Powering-on

Connect the charger if this is the first time of use. The red LED
fully charged (LED off) before switching on the unit by pressing the Start/stop key
After starting, the CALYS 50 / 75 / 100 is set by default to voltage measurement and voltage transmission. Connect the
Volts output to the Volts input as shown in the diagram below.
Check that the measurement displayed is the same as the simulated voltage.
To change the value of the simulated voltage, open the transmission window by pressing the OUT function key (F2). Enter
a numerical value using the alpha-numeric keys and confirm with the ENTER key.

B.2 Measurement

For all measurement functions, open the measurement window with function key F2 (IN). A rectangle surrounds the top
window on the screen.
106 / 164 NTA47227-300A8

GETTING STARTED

lights while the battery pack is charging. Wait until
for one second.