C.8.3 Preferences - AOIP CALYS 50 Mode D'emploi

CALYS 50 / 75 / 100
ADVANCED OPERATION
C.8.3 Preferences
To display the Preferences dialogue box, use the Configuration Setup Preferences... menus.
The adjustable parameters are:
Filtering: Used to average measurements before display. When filtering is switched off, the integration time for
measurements is 0.5 seconds.
Resolution: Used to adjust the resolution of the measurements when displayed. There are three possible choices:
HIGH: displays measurements with the highest possible resolution.
AVERAGE: displays one digit fewer compared with the HIGH resolution mode.
LOW: displays two digits fewer compared with the HIGH resolution mode.
Temperature units: used to select the temperature units, either °C, °F or K, for measurements and simulation.
Lighting: used to set the on time of the lighting before it is switched off to save the batteries.
Beep keys: used to switch on or off the transmission of an audible signal when pressing keys on the keyboard.
Language: used to select the language of the display in menus, dialogue boxes and on-line help.
150 / 164 NTA47227-300A8