Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CALYS 50 / 75 / 100
A.2.7
Batteries and charger
Precautions to be taken if battery charge is low:
On reception of your CALYS 50 / 75 / 100 it can happen that the batteries are not sufficiently charged for optimum
operation or even for starting up the device.
It is therefore required to connect the device to the mains (see paragraph A.2.4) and to wait for a few minutes before
starting it up (by pressing the On/Off button).
During normal operation:
When the
symbol flashes on the display, the battery should be recharged at the earliest. Connect the charger to the
network, the charge indicator (red LED)
for a complete recharge and disconnect the charger when the charge indicator
Warning
Only use the mains adaptor supplied with the calibrator.
The charger can be used with voltages of between 100 VAC and 250 VAC.
The charger is for indoor use only, at an ambient temperature not exceeding 40°C (104°F).
A.2.8
Replacing the battery pack
To replace the battery pack, contact your dealer.
A.2.9
Back-up battery (date and time)
Date and time are saved when the instruments is switched off on a 3 V Lithium battery (CR1225 type).
A.2.10 Stand
The stand gives a good angle of view when the CALYS 50 / 75 / 100 is placed on a desk. Unfold the stand on the back of
the unit and place the CALYS 50 / 75 / 100 on a desk as shown below.
A.2.11 Strap
The CALYS 50 / 75 / 100 is supplied with an untearable strap and two pins to attach the strap to the case.
Before attaching the strap, pass the free end through the fixing loop as in the diagram.
Feed the ends of the strap through the two slots on each side of the case. Insert the two pins into the strap and pull the
strap to lock the pins in the case.
94 / 164
NTA47227-300A8
on the front panel lights up. Leave the charger switched on for about 3 hours
GENERAL
goes off on the front panel.
Publicité
Chapitres
Table des Matières
