Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CALYS 150
Batteries and charger
Precautions to be taken if battery charge is low:
On reception of your CALYS 150 it can happen that the batteries are not sufficiently charged for optimum operation or even
for starting up the device.
It is therefore required to connect the device to the mains (see paragraph A.2.4) and to wait for a few minutes before starting
it up (by pressing the On/Off button).
During normal operation:
When the
symbol is flashing, the battery should be recharged as soon as possible. Connect the charger to power
system, the charge indicator (red LED)
a complete recharge and disconnect the charger when the charge indicator
Warning
Only use the mains adaptor supplied with the calibrator.
Replacing the battery pack
The battery pack should be changed once a year for optimal autonomy of instrument. To replace the battery pack, contact
your dealer.
Backup battery (date and time)
Date and time are saved when the instruments is switched off on a 3 V Lithium battery (CR1225 type).
Stand
The stand gives a good angle of view when the CALYS 150 is placed on a desk. Unfold the stand on the back of the unit
and place the CALYS 150 on a desk as shown below.
Strap
The CALYS 150 is supplied with a strap and two pins to attach the strap to the case.
Before attaching the strap, pass the free end through the fixing loop as in the diagram.
Feed the ends of the strap through the two slots on each side of the case. Insert the two pins into the strap and pull the strap
to lock the pins in the case.
110 / 194
NTA47224-300A9
on the front panel lights up. Leave the charger switched on for about 3 hours for
GENERAL
goes off on the front panel.
Publicité
Chapitres
Table des Matières
