Staircase Mode - AOIP CALYS 150 Mode D'emploi

CALYS 150

Staircase mode

This mode is used to program an incremental progression of the active transmission function.
When this mode is active, the
The function key launches a cycle of increasing increments and the
increments.
The default parameters of this mode are displayed on the left hand side of the transmission window. To change these
parameters, press ENTER or use the Menu
The parameters of a staircase are:
B: minimum amplitude of the signal.
H: maximum amplitude of the signal.
I: amplitude of the increment
T: duration of the steps in seconds
Delay: delay in seconds between launching the staircase and transmission of the first increment.
During generation of a staircase, a progress bar indicates the state of progress. The function keys control generation:
The key stops generation at any time
The key suspends generation
The key commences or resumes generation
An icon in the transmission window indicates suspended generation.
160 / 194 NTA47224-300A9
icon appears in the transmission window.
Mode.
ADVANCED OPERATION
function key launches a cycle of decreasing