Longines L441 Mode D'emploi page 28

30 CALIBRE L441
14. Read result under TABLE A
If the measured time is more than 60, 120 or 180 seconds,
these transitions are displayed on the red arc of the tables
counter.
• Seconds are displayed on the central counter.
• Hundredths of a second are displayed on the central counter,
and read on the dial flange.
• The penalties on the pts/sec penalties counter are displayed
in base 4.
OR
14. Read result under TABLE C
If the measured time is more than 60, 120 or 180 seconds,
these transitions are displayed on the black arc of the tables
counter.
• Seconds are displayed on the central counter.
• Hundredths of a second are displayed on the central counter,
and read on the dial flange.
• The penalties on the pts/sec penalties counter are displayed
in base 4.
• It is possible to find out the proportion of the time to complete
the round, and the proportion due to penalties, using push-
piece .
PRESS
To go back to the official, time press push-piece .
PRESS
NB Time is the only criterion adopted under TABLE C.
Longines_MDE-L441.indb 30
15. Reset
PRESS
Press push-piece to reset the chronograph and time the next
rider, without changing programming.
Then restart at step No.9.
INITIALISE
The settings can be initialised at any time and from
any mode by pressing and holding push-piece
4 seconds.
The watch will enter CHRONOGRAPH mode.
Furthermore, this action reinitialises the JUMPING mode
programming.
You can then go through the JUMPING mode program-
ming steps from the beginning.
for
01.04.15 14:44