Longines L441 Mode D'emploi page 25

3. Select TABLE A
PRESS
• The tables counter hand completes one high-speed rotation.
Default configuration with TABLE A applied.
4. Save TABLE A selection
PRESS
• The central counter seconds hand completes one high-speed
rotation.
• The tables counter hand completes one high-speed rotation.
• Program the allotted round time.
5. Program allotted time
and
PRESS
• Allotted time programmed with the central counter seconds
hand. The tables counter indicates when the time exceeds
60, 120 or 180 seconds.
• Each press on push-piece
central counter by one second.
• Each press on push-piece
central counter by one second.
Pressing and holding push-piece
decrements the counter in 15-seconds steps.
6. Save allotted time
PRESS
• The pts/sec penalties counter hand completes one high-
speed rotation.
• Program the number of penalties added for exceeding the
allotted time.
Longines_MDE-L441.indb 27
increments the chronograph
decrements the chronograph
or increments or
7. Program the number of penalties added for
exceeding the allotted time pre-programmed in
step No.5
and
PRESS
• Default value, 1 penalty point is added every 4 seconds
started.
• The pts/sec penalties counter points to 4.
• Alternatively, you can select 1 penalty point for every second
started.
moves the pts/sec penalties counter
• Pressing push-piece
hand to 1.
moves the pts/sec penalties counter
• Pressing push-piece
hand to 4.
8. Save final programming
2 SECONDS
• The central counter seconds hand and chronograph
hundredths of a second counter hand are positioned
to 12 o'clock.
• The tables counter hand points to
• The pts/sec penalties counter hand points to zero.
The watch is ready to time a jumping competition round under
TABLE A, with an allotted time programmed in step No.5.
You can exit JUMPING mode programming after each setting
step.
2 SECONDS
OR
Select TABLE A
8. Back to step No.3
Select TABLE C
PRESS
CALIBRE L441 27
A.
01.04.15 14:44