Snow Thrower Operation - Honda HSM1380i Manuel De L'utilisateur

Masquer les pouces Voir aussi pour HSM1380i:

Table des Matières

Les langues disponibles

Before operating this equipment you should read and understand the

SAFETY INSTRUCTIONS on page 3 through 8.

Efficiency of the snow removal work is significantly affected by the snow condition

(e.g. dry, wet etc.). Adjust the skid position, the scraper position, and the auger

housing height as needed for optimum snow removal.

Skid and scraper

Adjust the skid for the auger housing ground clearance best suited to your snow

removal conditions.

To prevent accidental starting, turn the engine switch to the OFF position

and remove the key from the engine switch.

1. Hold the auger housing horizontally and lower the auger on the ground by

operating the auger control switch.

2. Turn the engine switch OFF and remove the key from the engine switch.

3. Loosen the bolts and adjust the skid and scraper height in accordance with

the road surface condition where you are to clear the snow (see pages 50 and

7. SNOW THROWER OPERATION

Table des Matières