8. Reinstall the batteries in their original position.
9. Connect one battery joint cable terminal at the battery A positive (+)
terminal, and connect the other cable terminal at the battery B negative (–)
terminal.
10.Reinstall the battery set plate and tighten the nuts.
11.Connect the positive (+) cable at the battery B positive (+) terminal, and then
the negative (–) cable at the battery A negative (–) terminal.
12.Coat the battery terminals with grease.
13.Reinstall the rear cover by aligning the grommets with the projections of the
rear cover, and tighten the knobs securely.
SPRING
Install the upper side of the rear
cover between the right and left
springs.
CAUTION:
When disconnecting the battery cable, be sure to disconnect the battery
negative (–) terminal first. Connect the positive (+) terminal first, then the
negative (–) terminal. Never disconnect the battery cables in the reverse
order; that could cause a short circuit if a tool contacts the terminals.
This symbol on the battery means that this product must not be treated
as household waste.
NOTE:
An improperly disposed of battery can be harmful to the environment and
human health.
Always confirm local regulations for battery disposal.
92
REAR COVER
KNOBS
GROMMET
PROJECTION
GROMMET
REAR COVER
PROJECTION