Honda HSM1380i Manuel De L'utilisateur page 56

CAUTION:
Use the LOW position (i.e. position for clearing hardened snow) only for
clearing hardened snow. Do not set the auger housing in this position while
clearing soft snow or clearing on a bumpy road. This can damage the road
surface or cause stones to be thrown out of the auger, which is very
dangerous. Also, it can cause excessive wear and damage to the snow
clearing part of the snow thrower.
NOTE:
• When the ICS switch (HSM1380i) is in ON/the mode selector switch (HSM1390i)
is in AUTO or POWER, the auger housing automatically rises while going in
reverse.
In case the auger clutch switch is in the ON position, the auger is automatically
returned to the original position when the snow thrower is transporting
forward again (ETDR type).
• If you want to stop the automatic movement of the auger housing, turn off
the ICS switch (HSM1380i) and change the mode selector switch (HSM1390i)
to the ''SELF'' position.
• To stop the automatically movement of the auger housing, push the control
switch once to the opposite direction of the movement.
• Frequent operation of the auger housing control switch activates the
protection function and makes the drive control warning indicator (orange)
blink, which prevents you from adjusting the snow clearing part of the snow
thrower. Stop operating the auger housing control switch and wait a few
seconds before operating the switch again.
53