Honda HSM1380i Manuel De L'utilisateur page 55

Auger housing height
1. Operate the auger housing control switch back and forth. The auger housing
height can be adjusted without discrete steps.
To raise: Pull the auger housing control switch to UP.
To lower: Push the auger housing control switch to DOWN.
2. Release the auger housing control switch, and the auger housing is secured
in the position.
HIGH: Use this position when clearing the snow in steps and use it when
reversing or driving the snow thrower. (When the ICS switch
(HSM1380i) is ON/the mode selector switch (HSM1390i) is AUTO or
POWER, use this position when reversing the snow thrower.)
MIDDLE: Position for normal clearing. (Use this position to clear the snow
normally.)
LOW: Position for clearing hardened snow. (Use this position when the
snow you are to clear is hardened and the snow clearing part of
the snow thrower tends to get raised.)
[Example: HSM1380i (ETDR type)]
52
DOWN DOWN DOWN
UP UP UP
AUGER HOUSING
DOWN DOWN DOWN
UP UP UP
AUGER HOUSING AUG UGER HOUSIN
CONTROL SWITCH CONTRO ROL SWITCH
HIGH (UP)
MIDDLE
LOW (DOWN)
OUSING