Fuel Gauge; Pre-Operation Check - Honda HSM1590i Manuel De L'utilisateur

Check the snowblower on level ground with the engine stopped.
To prevent accidental start-up, remove the engine switch key before
performing the pre-operation check.
Fuel
Inspection:
Check whether the fuel gauge needle is in the FULL position.
If the needle is not in the position, fill the fuel tank to the level shown.
Refilling:
Use unleaded gasoline with a Research Octane Number of 91 or
higher (a Pump Octane Number of 86 or higher).
Never use stale or contaminated gasoline or an oil/gasoline mixture.
Avoid getting dirt or water in the fuel tank.
Remove the fuel filler cap and fill the tank with the recommended
gasoline.
Do not fill the fuel tank completely. Fill tank to approximately
25 mm (1 in) below the bottom of the fuel filler neck to allow for fuel
expansion.
After refueling, tighten the fuel filler cap securely by turning it until it
sounds three times.
FUEL FILLER CAP
FULL

FUEL GAUGE

PRE-OPERATION CHECK

5.
MAXIMUM
FUEL LEVEL
FUEL FILLER NECK
Approx. 25 mm
(1 in)
31