Honda HSM1380i Manuel De L'utilisateur page 36

Change the initial position (auger housing return position set at present) in case
of the following.
1. When you do not want to lower the auger housing to be level to the ground,
as the gravel can be caught in the auger during clearing on a graveled ground.
2. When the scraper/skid position was changed, making the initial position no
longer adequate for clearing the snow.
3. When each part of the snow thrower is worn, making the initial position no
longer adequate for clearing the snow.
4. When you want to change the initial position to a position you want.
Park the snow thrower on firm, level ground to change the initial position.
Push for 5sec. or longer Push for 5sec. or longer Push for 5sec. or longer
AUGER HOUSING CONTROL SWITCH
RESET SWITCH SET SWI WITCH
– 1.Turn the engine switch to the ON
position (see page 46).
– 2.Push the reset switch and hold it
pushed for five seconds or longer.
• The auger housing moves to the
initial position by pushing the
reset switch. Keep pushing the
reset switch.
– 3.Release the reset switch and
check whether the reset switch
indicator is blinking.
– 4.Operate the auger housing
control switch to set the auger
housing in a height position you
want.
33