Honda HSM1380i Manuel De L'utilisateur page 59

CAUTION:
[HSM1390i]
Do not turn the mode selector switch to another position while the snow
thrower is moving. The electronic control unit will interpret this as a failure;
the snow thrower will stop moving and the auger will stop turning.
When the snow thrower and auger stop moving/turning, move the main
shift lever to the N (neutral) position, release the drive clutch lever.
Check each part to verify it is in its proper position before resuming
operation.
3a. Clearing in AUTO mode (HSM1390i)
Setting the mode selector switch at the AUTO position can simplify
clearing the snow. AUTO mode keeps the auger from rising, adjusts the
engine speed automatically, etc.
CHUTER CONTROL SWITCH
AUGER HOUSING CONTROL SWITCH
56
RESET SWITCH
1) Operate the chuter control switch
to adjust the snow discharge
direction and angle (see page 30).
2) Operate the auger housing control
switch to adjust the auger to be
parallel to the road surface (see
pages 52 through 54).
[ETDR type]
• You can return the auger to the
initial position by pushing the
reset switch.
• If you return the auger to the
initial position by pushing the
reset switch, the auger can hit
against the road surface or can be
raised from the road, resulting in
some snow left on the ground,
depending on the road condition
and the position of the snow
thrower. Adjust the auger
position as needed.