Honda HSM1380i Manuel De L'utilisateur page 68

RESET SWITCH (ETDR type)
AUGER HOUSING CONTROL SWITCH
MAIN SHIFT
LEVER
DRIVE CLUTCH LEVER
N (neutral)
3) Operate the auger housing control
switch to adjust the auger to be
parallel to the road surface (see
pages 52 through 54).
[ETDR type]
• You can return the auger to the
initial position by pushing the
reset switch.
• If you return the auger to the
initial position by pushing the
reset switch, the auger can hit
against the road surface or can be
raised from the road, resulting in
some snow left on the ground,
depending on the road condition
and the position of the snow
thrower. Adjust the auger
position as needed.
4) Check that the main shift lever is in
the N (neutral) position and squeeze
the drive clutch lever.
65