Switching The Leds On/Off; Controlling The Vehicle - Reely Dune Fighter Notice D'emploi

Attention!
If the choke flap remains closed for too long or too much fuel was pumped into the combustion chamber and
the crank housing, the mixture will over-fatten and the motor will flood. The cable pull starter can be operated
only with increased force.
Refrain from further starting attempts and remove the excess fuel in order to prevent damaging the cable
pull starter and the engine!
k) Switching the LEDs On/Off
The LEDs can be switched on/off via channel 3 of the enclosed transmitter. For this, the receiver power supply must,
of course, be connected and activated.
l) Controlling the Vehicle
The following figures are only to illustrate the functions and do not necessarily correspond to the design of
the transmitter provided.
1. Release throttle/braking lever (neutral position), vehicle rolls to a halt (or does not move), motor runs idle
2. Drive forwards, pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; it does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping
Æ
Move the throttle/braking lever for the drive function very cautiously and do not drive too fast at the beginning
until you get used to the reactions of the car.
Do not make any quick and jerky movements with the operating elements of the remote control.
If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly
(also see operating instructions of the remote control).
49