Switching On The Remote Control; Connecting The Battery Pack To The Drive Control; Activating The Drive Control; Attaching And Fastening The Car Body - Reely 1:10 EP Monstertruck Titan 4WD RtR Notice D'emploi

f) Switching on the remote control
Pull out the telescopic antenna completely, f you have not already done so.
Turn the remote control on before connecting the battery pack with the drive control. Place the ON /OFF switch into the
"I" position. The red "BATT" LED lights up.
If the LED flashes, the batteries or rechargeable batteries in the remote control are weak and should be
exchanged for new ones as fast as possible.
g) Connecting the battery pack to the drive control
Prior to connecting the battery pack to the drive control, activate the remote control (transmitter, see chapter 9. d), e)
and 9. f).
To prevent a sudden starting of the wheels and therefore an uncontrolled starting of the model (e.g. if the trimming for
the drive is maladjusted), place the model vehicle on a suitable surface or mount, so that the wheels can turn freely in
case there is a fault.
Now connect the rechargeable battery pack to the control unit.
h) Activating the drive control
Slide the switch of the drive control to "ON" and check the drive and steering function of the vehicle.
In general, the manufacturer's default settings are correct and no adjustments are required.
If the vehicle's motor starts although the throttle is in central position, you can program the drive control. For this
purpose, see chapter 11 .
i) Attaching and fastening the car body
Guide the tube of the antenna from underneath the car body through the hole intended for that purpose.
Now put the car body on the holders and fasten the vehicle lining with the safety clips removed at the start.
Your car is now ready for its first test run.
30