1. Unpacking the Game:
Unpack your new dartboard carefully, making sure all parts are included. The following components are
included in this set:
•
Electronic Dartboard
•
Soft tip replacement pack
•
12 Darts
•
AC power adapter
•
Owner's Manual
2. Mounting with AC power adapter
Choose a location to hang the dartboard where is about 10 feet
(3.048 m) of open space in front of the board. The "toe-line"
should be 7'9 1/4" (2.37 M) from the face of the dartboard.
Since this dartboard is powered with either an AC power
adapter , you could mount it anywhere or close to an electronic
outlet for convenience. No matter the dartboard has horizontal
or vertical hang hole(s), the center of bullseye should be 5'8"
(1.73 m) from the ground. Mark the center location on the wall.
Measure the distance between hang hole(s) and center. Then,
make the mark(s) for hang hole(s). Make sure the second mark
for hang hole is level with the first mark. Mount the dartboard
on the wall by lining up the hang holes on the back with the
screws. It may be necessary to adjust the screws until the board
fits snugly against the wall. If you want to mount the dartboard even more securely to the wall, you can fasten
four screws through the holes located in the catch ring area (the area outside the scoring segments).
3. Dartboard Functions (Please note that your dartboard may not include all functions)
POWER switch/button - Located on the lower right corner on the side of the dartboard. Be sure the AC Adapter
is plugged into the jack on the right side of the dartboard installed. Press the POWER switch to turn game on or
off.
START/HOLD button - This multi-function button is used to:
• START the game when all options have been selected.
• Put dartboard in HOLD status between rounds to allow player to remove darts from the target area.
BULL'S Delta IV
27