Electrical; Interface - Epson EPL-5000 Guide De L'utilisateur

Electrical

Voltage
Rated frequency
Rated current
Power consumption
Power consumption* in
Standby mode
* No option installed

Interface

The parallel interface connector pin assignments and a description of the interface
signals are shown in the table below.
Signal Return
Pin Pin
1 19
2 20
3 21
4 22
5 23
6 24
7 25
8 26
9 27
10 28
120 V model
90 V to 132 V
50 Hz to 60 Hz  3 Hz
5.5 A  10%
Less than 500 W
Less than 15 W
Signal Direction
STROBE IN
DATA 1 IN
DATA 2 IN
DATA 3 IN
DATA 4 IN
DATA 5 IN
DATA 6 IN
DATA 7 IN
DATA 8 IN
ACKNLG OUT
220 V model
198 V to 264 V
50 Hz to 60 Hz  3 Hz
3 A  10%
Less than 600 W
Less than 15 W
Description
STROBE pulse to read data. Pulse
width must be at least 0.5 µ s at the
receiving terminal.
These signals represent parallel
data bits 1 to 8, respectively. Each
signal is at HIGH level when data
is logical 1 and LOW when it is
logical 0.
About a 1- µ s pulse width. LOW
indicates data has been received
and the printer is ready to accept
more data.
Technical Specifications
A-5