Epson EPL-5000 Guide De L'utilisateur page 595

Left Offset
Allows you to adjust the printing position on the page
horizontally. The setting is in dots; each dot is 1/300 inch (0.0846
mm). You can move the printing position on the page up to
approximately 1/5 inch to the left (settings from 0 to 99).
Standby
Sets the Standby mode to Enable or Disable. When this setting is
enabled, the printer saves power by reducing the power to the
fixing heater whenever the printer receives no data for 15
minutes. The printer begins warming up as soon as you press the
On Line button or send data; it warms up and is ready to print
within 35 seconds. When Standby is disabled, the printer stays
warmed up and ready to print at all times.
Source Symbol Set
Available only when an optional font ROM is installed in LJ4L
emulation mode.
Destination Symbol Set
Available only when an optional font ROM is installed in LJ4L
emulation mode.
4-16
Remote Control Panel Utility