Epson EPL-5000 Guide De L'utilisateur page 521

After you select the font source, press u or d until the display shows
the font number you want; then press r to select the font. The font
number is based on the font option selected above. The available fonts
and their numbers are listed in the SelecType Level 1 FONT
SAMPLE printout.
If you selected a scalable font, you must perform an additional step
depending on whether the font is proportional or fixed pitch.
For a proportional font:
Press u or d to select the font's point size. Then press r once to set the
point size.
Menu/submenu
HEIGHT A # XXPT.>SET
If ****** appears on the display, the point size you selected is outside
the possible range of 4.00 to 999.75.
For a fixed pitch font:
Press u or d to select the spacing in characters per inch. Then press r
once to set the spacing.
Menu/submenu
PITCH A #XXCPI >SET
If ****** appears on the display, the character spacing you selected is
outside the possible range of 0.44 to 99.99.
STATUS SHEET
This option prints a status sheet that shows the current default
SelecType settings.
2-14
SelecType
Available options
4.00 to 999.75 (in steps of 0.25)
or ]]]]]]
Available options
0.44 to 99.99 (in steps of 0.01)
or ]]]]]