Epson EPL-5000 Guide De L'utilisateur page 525

SYSTEM CONFIG.
There are four submenus under the SYSTEM CONFIG. menu item.
Menu/submenu
A #SYSTEM CONFIG. >
Each submenu is explained in detail below.
PAGE PROTECT
Allocates additional printer memory to a print job. The factory setting
of 1 is sufficient for most uses of the printer. If you are printing
complex pages, you may need to increase this setting. When PRINT
OVERRUN appears on the display, it means that there is not enough
memory to print the job. When this happens, increase this setting. If
PRINT OVERRUN still appears, the printer does not have enough
memory to print your page. You will need to either reduce the
complexity of the page you are trying to print or increase the available
memory by adding additional memory.
Menu/submenu
A PAGE PROTECT OFF >
Note:
Normally, leave PAGE PROTECT set to 1. You should change this
setting only if a PRINT OVERRUN message appears.
2-18
SelecType
Available options
PAGE PROTECT
T-OFFSET
L-OFFSET
MEMORY LEFT
Available options
0 to 62
.