Printer Driver - Epson EPL-5000 Guide De L'utilisateur

Feed
Note:
Use the buttons shown below to perform the following:
On Line
o
Reset
o
Feed
o

Printer Driver

To take the maximum advantage of your printer, you need to set up
the printer driver used by your software.
If you use Microsoft
driver for HP LaserJet 4L emulation with the driver included in the
printer box. For instructions on installing the Windows driver, see
"Setting up the driver" in the Getting Ready! guide.
If you use DOS or an emulation other than HP LaserJet 4L, you can
use drivers other than the Windows driver that comes with your
printer.
Prints out the data in the printer's memory if you
press this button while the Feed light is lit. If you are
using more than one channel, you can print the data
received by each channel.
When the printer is on line, pressing the Feed button
switches the Toner Save Mode on and off. While the
printer is in the Toner Save Mode, "T" is shown at
the left side of the display.
Press to set the printer on line after you supply paper.
(The printer is off line when paper is out.)
Press to stop printing or to clear remaining data.
Press to print out data in the printer's memory.
(This button ejects the page even though the printer
has not received a form feed command.)
®
Windows™ 3.1 or later, you can set up the
Using Your Printer
1-7