Unpacking The System; Digit Power Dispenser Installation; Charging The Handpiece And Optional Wireless Foot Control - Dentsply Sirona digit Power Dispenser Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

3.2 Unpacking the System

As you unpack your digit Power
Optional Wireless Foot Control
(Available Separately):
1- Foot Control
1- Power Supply and Cord
1 Package- International Power Adapters
Cross-contamination
Do not reuse single use products. Dispose of in accordance with local regulations.
Reprocess reusable products as described in Section 4, Hygiene and Maintenance section.
Cartridge caps should be steam-autoclave sterilized prior to first use.
Reprocessing is mandatory following each use thereafter.
Additional Cartridge caps are available for purchase.
3.3 digit Power
Dispenser Installation
®
System Setup
• Both the handpiece and optional wireless foot control must be charged for at least 90 minutes prior to first use.

3.4. Charging the Handpiece and Optional Wireless Foot Control

• When the battery icon is empty (no bars), the handpiece must be charged.
• When the charge indicator light on the optional wireless foot control is solid orange, the foot control must be charged.
• A fully discharged handpiece or foot control will need approximately 3 hours to fully recharge.
When the handpiece is not in use, storage in the charging base is recommended. The handpiece has built-in safety circuitry that prevents
overheating or overcharging. The battery does not have "memory" and will always accept a full recharge.
1. Plug the power supply into a wall outlet.
Electrical Malfunction
• Connect to single phase AC power 100-240V power only. Otherwise, malfunction will occur.
• Do not unplug the power supply by pulling on the cord.
• Ensure Handpiece, charging base and optional wireless foot control are clean and fully dry before connecting power and/or inserting
handpiece into charging base.
2. Plug the power supply cord into the charging base (for handpiece charging) or directly into the optional wireless foot control
(for foot control charging).
3. Insert the handpiece into the charging base. Ensure contacts are clean and aligned. Handpiece should be stable in
the charging base.
A successful connection is shown as follows:
– The battery icon flashes and scrolls through all states of charge for handpiece. Battery icon will be solid when handpiece battery is at full
charge.
– A solid Green Charge Indicator on top of the optional, wireless foot control appears.
Unplug the power supply from the wall outlet (power mains) to remove all power to the unit being charged.
Dispenser, verify that the following components and accessories are included:
®
System
:
1- Handpiece with 1 preassembled cartridge cap
2- Cartridge caps
1- Charging Base for Handpiece
1- Power Supply and Cord
1- Package of 50 Disposable Polyethylene Barriers (Single Use)
1- Package International Power Adapters
5

Publicité

Table des Matières
loading

Table des Matières