moovo MD432KM Instructions Et Avertissements Pour L'installation Et L'utilisation page 6

KNOWLEDGE OF THE PRODUCT AND PREPARATION FOR INSTALLATION
STEP 2
STEP 2
2.1 PRODUCT DESCRIPTION AND INTENDED USE
In general, the series of devices that make up this product are used
to automate a garage door for residential use (Fig. 1). This type of
door may be "sectional" or "up-and-over"; up-and-over doors may
be projecting (during opening the door protrudes outwards) or non-
projecting, with springs or counterweights.
In particular, this kit is designed exclusively for the automation of
sectional garage doors. Therefore, to automate an up-and-over door,
a special oscillating arm must be fitted (model MA, not supplied with
the kit).
Any use other than that specified herein or in environmental
conditions other than those stated in STEP 3 must be considered
improper and is strictly forbidden!
This product (MD432KM) comprises an electromechanical gearmotor
with a 24 VDC motor and a three-piece guide with belt transmission.
The gearmotor is also equipped with a control unit.
The control unit comprises a PCB, a courtesy/warning light and a built-
in radio receiver, plus an antenna, which receives the commands sent
by a transmitter.
The control unit can control various types of manoeuvres, each
programmable and usable according to personal requirements.
Special functions are also available that allow for personalising the
operation of the automation.
The automation is designed for use with various accessories that
enhance its functionality and guarantee optimal safety. More specifically,
the control unit can memorise up to 150 keys of transmitter models
MT4V - MT4G and up to 4 pairs of photocells.
The product is mains-powered, and, in the event of a power failure
(blackout), it allows the door to be moved manually, by releasing the
drive carriage with a special cord or by means of a release mechanism
located externally (models KI1 or SPA2, not supplied with the kit).
SECTIONAL
1
6 6
2.2 COMPONENTS USED TO SET UP A COMPLETE
SYSTEM
Fig. "2" illustrates all components used to set up a complete system,
such as that shown in Fig. "8".
Some components shown in fig. 2 are optional and may not
be included in the package.
List of useful components:
[a] - electromechanical gearmotor
[b] - 3-piece guide for carriage + joining brackets
[c] - omega-shaped fastening bracket
[d] - gearmotor ceiling-mounting brackets
[e] - guide wall-mounting bracket
[f] - mechanical stops for stopping the carriage
[g] - unlocking system with metal smallwares (screws, washers, etc.)*
[h] - snap-on brackets for mounting the SRA1 device to the ceiling
[i] - external release mechanism KI1
[l] - knob for unlocking the automation
[m] - door drive rod (for sectional doors only)
[n] - bracket for connecting the drive rod to the door
[o] - oscillating arm and relative drive rod (model MA, for up-and-over
doors only)
[p] - transmitter (portable) models MT4V - MT4G
[q] - external release kit model SPA2
(*) Note – The bolts required for mounting the parts to the wall are not
included. The type of bolt will depend on the material and thickness of
the wall itself.
PROJECTING
WARNING!
NON-PROJECTING