moovo MD432KM Instructions Et Avertissements Pour L'installation Et L'utilisation page 18

STEP 8
STEP 8
START
RADIO
If, at the start of the following procedures, the "Set", "Radio"
and "Error" LEDs flash, it means that the programming
protection has been activated – See paragraph 14.3.1.
Consequently, the transmitters cannot be memorised.
To interrupt the following programming procedures at any
time, press the RADIO button or wait 20 seconds.
8.1 CHECKING THE RADIO TRANSMITTER
To check the transmitter, simply press one of its 4 keys, ensure that the
red LED [A flashes and that the automation performs the associated
command.
The command associated with each key depends on the way in which
it was memorised.
39
T1
T3
8.2 PROGRAMMING THE START BUTTON
This procedure can be used to programme the remote control button
connected to the automation start function.
ACTION
PRESS THE RADIO
01.
BUTTON FOR 1 SECOND
PRESS THE DESIRED
BUTTON ON EACH
02.
TRANSMITTER TO BE
PROGRAMMED
PRESS THE RADIO
BUTTON UNTIL THE LED
03. SWITCHES OFF OR WAIT
20 SECONDS TO EXIT THE
PROCEDURE
18 18
PROGRAMMING THE TRANSMITTER
SET
T2
T4
RESULT
The red "radio" LED
lights up steady
(if not, consult
paragraph 14.3.1)
The red "radio" LED
flashes
The red "radio" LED
switches off
8.3 PROGRAMMING THE BUTTON CONNECTED TO THE
OUT1 OUTPUT
This procedure can be adopted to programme the remote control
button connected to the "OUT1" output (terminals 1-2).
ACTION
PRESS THE RADIO BUT-
01.
TON FOR 1 SECOND
PRESS THE START BUT-
02.
TON FOR 1 SECOND
PRESS THE DESIRED KEY
03. ON ALL TRANSMITTERS
TO BE PROGRAMMED
PRESS THE RADIO KEY
UNTIL THE RADIO LED
04. SWITCHES OFF OR WAIT
20 SECONDS TO EXIT THE
PROCEDURE
8.4 PROGRAMMING THE BUTTON CONNECTED TO THE
COURTESY LIGHT MOUNTED ON THE SYSTEM
This procedure can be adopted to programme the remote control
button connected to the LED light mounted on the system.
ACTION
PRESS THE RADIO KEY
01.
FOR 1 SECOND
PRESS THE SET BUTTON
02.
FOR 1 SECOND
PRESS THE DESIRED KEY
03. ON ALL TRANSMITTERS
TO BE PROGRAMMED
PRESS THE RADIO
BUTTON UNTIL THE
RADIO LED SWITCHES
04.
OFF OR WAIT 20
SECONDS TO EXIT THE
PROCEDURE
8.5 DELETING ALL MEMORISED TRANSMITTERS
This operation deletes all memorised transmitters.
ACTION
PRESS THE RADIO
BUTTON FOR 4
01. SECONDS AND RELEASE
IT WHEN THE LED
STARTS FLASHING
PRESS THE RADIO
02. BUTTON AGAIN FOR 1
SECOND
03. DELETION COMPLETED
RESULT
The red
"radio" LED lights up
steady
The red "radio" LED
will remain steady lit
and the red "error"
LED will light up steady
The red "radio LED
flashes and the red
"error" LED will light
up steady
The red "radio"
LED and the red
"error"error" LED
switch off
RESULT
The red "radio" LED
lights up steady
The red "radio" LED
will remain steady lit
and the yellow "set"
LED will light up
steady
The red "radio" LED
flashes and the yellow
"set" LED will remain
steady lit
The red "radio" LED
and the yellow "set"
LED switch off
RESULT
The red "radio" LED
flashes
The red "radio" LED
flashes fast
The red "radio" LED
switches off