moovo MD432KM Instructions Et Avertissements Pour L'installation Et L'utilisation page 19

8.6 DELETING A SINGLE TRANSMITTER
This operation deletes a single transmitter from the memory.
ACTION
PRESS THE RADIO
BUTTON FOR 4 SECONDS
01. AND RELEASE IT WHEN
THE RADIO LED STARTS
FLASHING
PRESS THE SET BUTTON
02.
FOR 1 SECOND
PRESS A BUTTON ON THE
03. TRANSMITTER YOU WISH
TO DELETE
PRESS THE RADIO KEY
UNTIL THE RADIO LED
04. SWITCHES OFF OR WAIT
20 SECONDS TO EXIT THE
PROCEDURE
8.7 PROGRAMMING THE TRANSMITTER REMOTELY
This procedure can be adopted to programme a new transmitter
without accessing the control unit, but keeping it close by.
To perform this procedure, it is necessary to have a transmitter
programmed previously, so that its functions can be transferred.
STEP 9
STEP 9
PAUSE
OBSTACLE
FORCE
START
RADIO
DIP 1 & 2
To restart the system it is necessary to perform one of the following
programming procedures:
-basic programming of the automation movement: self-recognition
of the manoeuvre times and slowdown start points.
-advanced programming of the automation movement: self-
recognition of the manoeuvre times and manual adjustment of the
RESULT
The red "radio" LED
lights up (if not, consult
paragraph 14.3.1)
The red "radio" LED
flashes and the yellow
"set" LED will lights up
steady
The red "radio" LED
flashes and the yellow
"set" LED flashes
The red "radio" LED
and the yellow "set"
LED switch off
LEARNING THE DOOR OPENING AND CLOSING POSITIONS
SET
T1
T1
slowdown start points.
If, at the start of the following procedures, the "set",
"radio" and "error" LEDs flash, it means that the control
unit protection has been activated – See paragraph "14.3.1
Activating/deactivating the control unit protection".
To interrupt the following programming sequences at
any time, simultaneously press the set and radio buttons.
9.1 BASIC PROGRAMMING OF THE AUTOMATION
MOVEMENT
Through this procedure the control unit memorises the work times
and the force required to open and close the system.
The slowdown points are set automatically to ensure that
the door arrives properly at the end of its path.
ACTION
POSITION THE DOOR
01.
MIDWAY ALONG THE
OPENING PATH
PRESS THE SET
BUTTON UNTIL THE
02.
MANOEUVRE STARTS
(approx. 3 s)
RELEASE THE SET
03.
KEY
THE DOOR EXECUTES
04. A PARTIAL OPENING
MOVEMENT
T2
IN A PREVIOUSLY
MEMORISED TRANSMITTER,
PRESS AND HOLD KEYS T1
AND T2 TEMPORARILY FOR
4 SECONDS
T2
ON THE TRANSMITTER
TO BE PROGRAMMED,
PRESS AND HOLD KEYS T1
AND T2 TOGETHER FOR 4
SECONDS
RESULT
The yellow "set" LED
flashes (if not, consult
paragraph 14.3.1)
The yellow "set" LED
lights up steady
The yellow "set" LED
remains steady lit
19 19