Publicité
Les langues disponibles
Les langues disponibles
– the system's power supply network must include a disconnection
device (not supplied) with a contact opening gap permitting complete
disconnection under the conditions envisaged by Overvoltage
Category III.
– handle the product with care during installation and avoid crushing,
knocks, falls or contact with liquids of any kind. Keep the product
away from sources of heat and open flames. Failure to observe the
above can damage the product and increase the risk of danger or
malfunctions. Should this happen, stop installation immediately and
contact Customer Service.
– the manufacturer declines all liability for damages to property, objects
or people resulting from failure to observe the assembly instructions.
In such cases, the warranty for material defects is excluded.
– the weighted sound pressure level of the emission A is lower than
70 dB(A).
– permanently attach the trapping hazard warning labels in a highly
visible location or near the fixed control devices (if present).
– permanently attach the manual unlock (manual manoeuvre) label
close to the manoeuvring element.
– after installation, make sure that the motor prevents or stops the door
from opening when the latter is loaded with a 20 kg weight secured
to the centre of its bottom edge (for drive motors that can be used
with doors having opening widths exceeding 50 mm in diameter).
– after installation, make sure that the mechanism is properly adjusted
and that the motor reverses when the door collides with a 50 mm-
tall object placed on the ground (for drive motors incorporating a
trapping safety system that intervenes when the bottom edge of the
door encounters an obstacle).
– Following installation, check and ensure that no door parts obstruct
public roadways or pavements.
5 5
Publicité
