Publicité
Les langues disponibles
Les langues disponibles
and declaration of incorporation of "partly completed machinery"
Rev: 0
Language: English
Manufacturer's Name:
Address:
Authorized Person to constitute the technical documentation:
Address:
Type of product:
Model/Type:
Accessories:
The undersigned Roberto Griffa, in the role of Chief Executive Officer, declares under his sole responsibility that the product described above
complies with the provisions laid down in the following directives:
•
Directive 2014/53/EU (RED)
•
Directive 2011/65/UE (RoHS II)
The product also complies with the following directives according to the requirements envisaged for "partly completed machinery"
(Annex II, part 1, section B):
Directive 2006/42/EC of the EUROPEAN PARLIAMENT AND COUNCIL of 17 May 2006 related to machinery and amending the
Directive 95/16/EC (recast).
● It is hereby stated that the relevant technical documentation has been compiled in accordance with annex VII B of Directive
2006/42/EC and that the following essential requirements have been fulfilled:
1.1.1 1.1.2 1.1.3-1.2.1-1.2.6-1.5.1-1.5.2-1.5.5-1.5.6-1.5.7-1.5.8-1.5.10-1.5.11
● The manufacturer undertakes to transmit to the national authorities, in response to a reasoned request, the relevant information on
the " partly completed machinery ", while maintaining full rights to the related intellectual property.
●Should the " partly completed machinery" be put into service in a European country with an official language other than that used in
this declaration, the importer is obliged to arrange for the relative translation to accompany this declaration..
● The "partly completed machinery" must not be used until the final machine in which it is incorporated is in turn declared as
compliant, if applicable, with the provisions of directive 2006/42/EC.
The product also complies with the following standards:
EN 60335-1:2012+A11:2014+A13:2017+A1:2019+A2:2019+A14:2019+A15:2021,
EN 60335-2-103:2015, EN 62233:2008
EN IEC 61000-6-2:2019, EN IEC 61000-6-3:2021
Place and Date:
Oderzo, 04/05/2022
Declaration of conformity
EU Declaration of Conformity (N. 793/MD432)
Nice S.p.A.
Via Callalta n°1, 31046 Oderzo (TV) Italy
Nice S.p.A.
Via Callalta n°1, 31046 Oderzo (TV) Italy
Pre-assembled 24Vdc geared motor with built-in control unit and
receiver
MD432
Refer to the catalog
Health protection standards (art. 3(1)(a))
·
EN 62479:2010
Electrical safety (art. 3(1)(a))
·
EN IEC 62368-1:2020
·
E
lectromagnetic compatibility (art. 3(1)(b))
·
EN 301 489-1 V2.1.1:2017, EN 301 489-3 V2.1.1:2019;
·
Radio spectrum (art. 3(2))
EN 300 220-1 V3.1.1:2017, EN 300 220-2 V3.2.1:2018
Ing. Roberto Griffa
(Chief Executive Officer)
V V
Publicité
