moovo MD432KM Instructions Et Avertissements Pour L'installation Et L'utilisation page 12

11. from the opening side of the door, position the wall mounting
bracket (J) on the guide and lock it by inserting the pin and cotter
pin ("Fig. 17")
17
J
FOR UP-AND-OVER DOORS ONLY
12.
If the door to be automated is an "up-and-over" door (projecting
or non-projecting - Fig. 1), it is necessary to install the relevant
oscillating arm model MA (Fig. 18). Proceed with the
assembly of the various arm components. IMPORTANT –
Make sure that you move the arm as close as possible to
the door's handle.
To assemble the drive rod, refer to point 13.
Note - follow the instructions contained in the packaging to
assemble the accessory.
18
12 12
13. mount the door mounting bracket (K) on the drawbar (L)
14. insert the relevant pin (M) into the drawbar and lock it in place with
the cotter pin (N) ("Fig. 19")
19
15. mount the pin (O) onto the drawbar (L)
16. attach the drawbar to the motor carriage ( P)
17. lock the bracket in place using the two screws ("Fig. 20")
20
O
L
Verify that the distances chosen for installing the product are
compatible with the limit distances (see "Fig. 4").
18. fasten the wall mounting bracket (J) to the wall above the door or
to the ceiling ("Fig. 21")
21
K
M
L
N
P
J