moovo MD432KM Instructions Et Avertissements Pour L'installation Et L'utilisation page 28

STEP 18
STEP 18
MD432KM is manufactured by Moovo. In order to improve its products, Moovo reserves the right to modify their technical specifica-
tions at any time without prior notice. In any case, the manufacturer guarantees their functionality and suitability for their intended use.
Note: all technical specifications refer to a temperature of 20°C.
MD432KM
Type
Peak starting torque
[corresponds to the force required
to get the door moving]
Nominal torque [corresponds
to the ability to develop a force
capable of keeping the door
moving]
No-load speed [corresponding
speed if the maximum speed is
programmed]
Maximum frequency of
operating cycles
Maximum continuous operation
time
Operating limits
Power supply for MD432KM
Maximum power input
Insulation class
Emergency power supply
Courtesy light for MD432KM
Warning light output
"S2 Photo" input
"Start" input (see SbS)
"S1 Edge" input
"STOP" input
Operating temperature.
Protection rating
Dimensions and weight
DESCRIPTION
Type
Technology adopted
Frequency
Encoding
Buttons
Radiated power
Power supply
Battery life
Ambient operating temperature
Use in particularly acidic,
saline or potentially explosive
atmospheres
28 28
PRODUCT TECHNICAL SPECIFICATIONS
Electromechanical gearmotor for the automatic movement of garage doors for residential use, inclusive
of an electronic control unit with integrated radio receiver for "MT4..." transmitters
9.9 Nm [550N]
4.95 Nm [275N]
0.14 m/s
30 cycles per day (the control unit allows up to the maximum value stated in "Table 2: limits in
relation to the door height" and "Table 3: limits in relation to the force required to move the
door")
4 minutes (the control unit limits continuous operation to the maximum described in "Table 2: limits
in relation to the door height" and "Table 3: limits in relation to the force required to move the
door")
In general, MD432KM is suitable for automating sectional and up-and-over doors that fall within the
dimensions indicated in "Table 1: gearmotor operating limits" and within the limits specified in
"Table 2: limits in relation to the door height" and "Table 3: limits in relation to the force
required to move the door".
230 V (±10%) 50/60 Hz.
200 W
1 (a safety earthing system is required)
No
LED
for 1 warning light
For safety devices such as photocells
For normally open contacts (closing of the contact triggers the "Step-by-Step" command)
For normally open contacts and/or for 8.2 KΩ constant resistor, or normally closed contacts with
self-recognition of the "normal" state (any variation from the memorised status triggers the "STOP"
command and a brief reversal).
For normally closed contacts (opening of the contact triggers a "STOP" command).
-20°C ... +50°C
IP40: use only in indoor or protected environments
390 x 210 x h 130 mm / 3.3 kg
MT4V - MT4G TRANSMITTER
DATA
Radio transmitters for controlling automations on gates and garage doors
AM OOK radio encoded modulation
433.92 MHz (± 100 kHz)
Rolling code with 64-bit code (18 trillion combinations)
4 (each key can be used to memorise the various commands of the same control unit or different control
units)
e.r.p 1 dBm
3V +20% -40% with 1 lithium battery type CR2032
3 years, estimated on the basis of 10 commands/day, each lasting 1 s at 20°C (at low temperatures the
efficiency of the batteries decreases)
–20°C to 50°C
No