Moustache Lundi 20 Manuel Utilisateur page 77

4.6.1 IN THE CASE OF A PLETSCHER KICK-STAND
You can easily adjust the length of the kick-stand using a 2.5mm
allen key. To do this, unscrew the pressure screw; adjust it to the
desired length, then retighten the pressure screw to 3-5 Nm.
4.6.2 IN THE CASE OF A MOUSTACHE KICK-
STAND
You can adjust the length of your Moustache kick-stand. You
simply need to pull the little plastic clip as in the Figure 33a, then,
whilst holding the clip, adjust it to the desired length. Finally let
go of the clip. If the displacement of the little plastic clip is not sufficient to allow the lower part
of the kick-stand to move as required, you can loosen the cross-head screw by a quarter turn
using a cross-head screwdriver until you have enough movement to slide the lower part of the
kick-stand as in Figure 33b.
Figure 33a.
4.7 LUGGAGE RACKS AND MUD GUARD
4.7.1 MUD GUARD
All our urban models are equipped with tubular mud guards ensuring
a high level of stiffness. Always respect a minimum gap of 6mm
at all points between the tire and the mud guard (Figure 34). This
should be checked regularly and at each time that you change the
tires on your bike. Keep to the size of tire equipped on your bike
at sale in order to keep the right size gap. If the gap is less than
6mm contact your retailer so that he/she can adjust as necessary.
Regularly check that the fixation points on your mud guard are tight.
(Table 2 Recommended torque values)
4.7.2 LUGGAGE RACKS
We have fitted some of our models with specific rear racks. These racks are designed for a
maximum load of 25 kg (including battery if your frame has a rack-mounted battery). Our Lundi
20 has a rear rack designed for a maximum load of 70 kg. Under no circumstances should you
attempt to modify your carrier, its mounting points or exceed the maximum load value as this
may damage your bike and result in a fall and injury. In these cases, your bike or rack will not
be covered by the warranty either.
FR EN
Figure 32.
Pletscher kick-stand settings.
Figure 33b.
DE IT ES
2,5
6 mm
minimum
Figure 34. Minimum gap tire/mud
guard.
79
NL