Moustache Lundi 20 Manuel Utilisateur page 61

FR EN DE IT ES NL
3 | RIDING POSITION
Each Moustache is unique, and you are too! It is therefore essential to adapt your Moustache
to your morphology for optimal comfort.
3.1 HAUTEUR DE SELLE
The first set up to carry out on your Moustache is the
saddle height. Once again, your local retailer can help you
do this. You must not hesitate to adjust this if you do not
find the correct height immediately.
We have a good tip to help you find the correct setting qui-
ckly: position the crank in line with the seat tube, without
being lopsided on the saddle and place your heel on the
pedal with your leg almost straight. (Figure 3).
N.B.: On the Lundi 27 model, the position is a little lowe, the
leg can stay slightly bent.
To adjust the height you need to open the seat clamp's
quick release or unscrew the screw on the seat clamp with
a 4 or 5 mm allen key.
Once the height is adjusted, close the quick release lever.
Figure 3. Hauteur de selle idéale
If necessary adjust the tightness level on the opposite nut so that the lever tightens around
midway through closing.
In the case of a seat clamp with screw, tighten the screw to the recommended torque level that
you will find in the section 4.9 TIGHTENING TORQUE VALUES or marked next to the screw.
WARNING!
For seat clamps with screws, you should never go over the
recommended torque level, this could damage your frame.
Never go over the maximum height level on your seat post marked by
the engraving « INSERT MINI » OR « STOP ». This is for your safety, as
well as the reLiability of your bike. (See Figure 4).
If you cannot obtain the right saddle height without going past this
limit, contact your local retailer.
Figure 4. Maximum seat post output
63