Motion Detection" Function - Sygonix SY-4548736 Notice D'emploi

c) "Motion detection" function
This function enables to set three sensitivity levels for motion detection. The monitor/DVR can start recording upon
motion detection in the monitored area, e.g. when a person or a car moves within the surveillance area of the camera
optics.
Motion detection is based on recognising differences in the video image. If the wireless camera is aimed
e.g. at trees or bushes, the movement of leaves or branches can trigger a recording.
In case of frequent misrecords despite a low sensitivity, you should reorient the camera or mount it in a
different location.
Proceed as follows:
• Briefly press the "MENU" button (3, 31) on the monitor/DVR or the IR remote control to display the main menu.
• Use the " " or " " button to select the "Recording settings" submenu and briefly press the "
• Use the " " or " " button to select the "Motion detection" function and then briefly press the "
• Briefly press the "
• You can now use the "
or "Camera 4").
• Set the desired sensitivity using the "
- "Low" = low sensitivity
- "Medium" = medium sensitivity
- "High" = high sensitivity
• Confirm the setting by briefly pressing the "
The monitor/DVR then switches back to the previous menu. If you want to set sensitivity for another chan-
nel, proceed as described above.
• To go back one menu level or to exit the OSD menu, briefly press the "MENU" button (3, 31) on the monitor/DVR or
the IR remote control (multiple button pressed may be needed).
" button (6, 34) again in the following menu.
" or " " button to select one of the four channels ("Camera 1", "Camera 2", "Camera 3"
" or " " button.
" button (6, 34).
" button (6, 34).
" button (6, 34).
69