Camera Brightness" Function; Anti-Flicker" Function - Sygonix SY-4548736 Notice D'emploi

d) "Camera brightness" function
This function enables to set the image brightness separately for each wireless camera. You can thus adapt brightness
differences between the various wireless cameras/channels to one another.
Proceed as follows:
• Briefly press the "MENU" button (3, 31) on the monitor/DVR or the IR remote control to display the main menu.
• Use the " " or " " button to select the "Camera settings" submenu and briefly press the "
• Use the " " or " " button to select the "Brightness" function and then briefly press the "
• You can now use the "
or "Camera 4").
• Set the desired image brightness using the "
ness of the respective channel on the monitor/DVR display.
• Confirm the setting by briefly pressing the "
The monitor/DVR then switches back to the previous menu. If you want to set brightness for another chan-
nel, proceed as described above.
• To go back one menu level or to exit the OSD menu, briefly press the "MENU" button (3, 31) on the monitor/DVR or
the IR remote control (multiple button pressed may be needed).
e) "Anti-flicker" function
Operation of the wireless cameras in areas where the light from fluorescent/energy-saving lamps is visible in the
image can lead to undesirable flickering effects. This menu enables to set the mains voltage frequency in order to
avoid such effects.
Proceed as follows:
• Briefly press the "MENU" button (3, 31) on the monitor/DVR or the IR remote control to display the main menu.
• Use the " " or " " button to select the "Camera settings" submenu and briefly press the "
• Use the " " or " " button to select the "Anti-flicker" function and then briefly press the "
• Use the " " or " " button to switch between "50 Hz" and "60 Hz" (mains voltage frequency at the place of opera-
tion of the wireless cameras; this frequency makes fluorescent or energy-saving lamps "flicker").
• Confirm the setting by briefly pressing the "
ous menu.
• To go back one menu level or to exit the OSD menu, briefly press the "MENU" button (3, 31) on the monitor/DVR or
the IR remote control (multiple button pressed may be needed).
" or " " button to select one of the four channels ("Camera 1", "Camera 2", "Camera 3"
" or "
" button (6, 34).
" button (6, 34). The monitor/DVR then switches back to the previ-
" button. The higher the value, the higher the image bright-
" button (6, 34).
" button (6, 34).
" button (6, 34).
" button (6, 34).
59