System Settings" Submenu; Date & Time" Function; Formatting" Function - Sygonix SY-4548736 Notice D'emploi

13. "System settings" submenu

a) "Date & time" function
This function is used to set the date and time to be displayed in the video recordings. This is the only way you can
understand when e.g. a person has entered the surveillance area.
Proceed as follows:
• Briefly press the "MENU" button (3, 31) on the monitor/DVR or the IR remote control to display the main menu.
• Use the " " or " " button to select the "System settings" submenu and briefly press the "
• Use the " " or " " button to select the "Date & time" function and then briefly press the "
• Use the " " or " " button to switch between the year, month, day, hours, minutes and seconds settings.
• Change the selected value using the "
For a quick adjustment, press and hold down the corresponding button for a bit.
• Confirm the setting by briefly pressing the "
ous menu.
• To go back one menu level or to exit the OSD menu, briefly press the "MENU" button (3, 31) on the monitor/DVR or
the IR remote control (multiple button pressed may be needed).
b) "Formatting" function
If necessary, the inserted memory card can be reformatted. This function can be used not only to completely and
quickly erase the memory card, but also to reformat it to ensure that the memory card has the correct file format so
that the monitor/DVR recordings are stored on the memory card.
Proceed as follows:
• Briefly press the "MENU" button (3, 31) on the monitor/DVR or the IR remote control to display the main menu.
• Use the " " or " " button to select the "System settings" submenu and briefly press the "
• Use the " " or " " button to select the "Formatting" function and then briefly press the "
• Use the " " or " " button to choose between formatting or cancelling the function.
• Confirm the selection by briefly pressing the "
All existing data on the memory card will be permanently lost after formatting.
• The formatting process starts immediately after confirmation. A bar shows the progress.
• After the formatting process has been completed (or if you have cancelled the function), the monitor/DVR returns
to the previous menu.
• To go back one menu level or to exit the OSD menu, briefly press the "MENU" button (3, 31) on the monitor/DVR or
the IR remote control (multiple button pressed may be needed).
60
" or " " button.
" button (6, 34). The monitor/DVR then switches back to the previ-
" button (6, 34).
" button (6, 34).
" button (6, 34).
" button (6, 34).
" button (6, 34).