Oven Commissioning And Testing; Testing - Angelo Po COMBIFIT CF623E Manuel D'installation, D'utilisation Et De Maintenance

Secure the cable with the cable gland.
The feed voltage, when the machine is operating, should not vary in
relation to the rated voltage by more than ± 10%.
The applinace must be included into an equipotential
system whose efficency is checked in compliance with
the standards in force. For the connection use the clamp,
placed on the frame and marked with the symbol fig. 8,
to which you should connect a cable with the minimum
section of 10 mm².
1.6. Oven commissioning and testing
Before putting the oven into operation, you should carefully carry out
all the necessary checks to ascertain the conformity of the equipment
and installation of the appliance as provided by law and according to the
technical and safety instructions given in this manual.
You should also check that the compliance of the following:
The ambient temperature in the location where the oven is installed
should be greater than +4 ° C.
The cooking chamber should be empty.
All packages must have been completely removed, including the
protective film applied on oven's walls.
The vents and slits should be open and free of obstructions.
The parts of the oven that were disassembled for installation purposes
should be reinstalled.
The master switch should be closed and the water shut-off valve
upstream of the unit must be opened.

1.7. Testing

Oven should be tested by completing a cooking cycle to verify that the
equipment works properly, without any anomalies or problems.
Turn on the oven using the master switch T1 fig. 9 (next page)
Set a cooking cycle with temperature to 150 ° C, time set to 10 min.
and humidity to 25%.
Press the key T2 (fig. 9) "Start/Stop".
Carefully check the points given in the following list:
By pressing the power button T5 (fig. 9), the lights in the cooking
chamber light up and after 45 seconds, if not turned off before pressing
the button again, will turn off automatically.
The oven will stop if the door is opened and starts to work when the
COMBIFIT installation, use and maintenance manual
fig. 8
11