Alarms Description - Angelo Po COMBIFIT CF623E Manuel D'installation, D'utilisation Et De Maintenance

10. Alarms description
If an alarm is triggered, on temperature and time display is shown the
name of the alarm triggered.
The alarms managed are the following
Name Description
Chamber Chamber probe
probe failure
Pin Pin probe failure
probe
Safety Motor Alarm
motor
Peripheral Motor Inverter
Alarm
Chamber Chamber thermal
safety switch breaker
Hi temp Temperature inside
the technical
compartment is too
high
No There is no water to
water generate steam
Communica- Main board
tion communication
failure
Power fail Electric power
supply is
interrupted
Probe 4 Moisture control
probe 4 alarm
Probe 5 Moisture control
probe 5 alarm
38
Actions SOLUTION
Cooking Replace the chamber probe.
cycle block;
automatic
reset.
Manual reset. Replace the pin probe.
Cooking If the problem persists, contact
cycle block; the support center.
automatic
reset.
Cooking Cut off the power and power
cycle block; again.
automatic If the problem persists, contact
reset. the support center.
Cooking If the problem persists, contact
cycle block; the support center.
automatic
reset.
Cooking Check the perimeter of the oven
cycle block; (slits) and the correct operation
automatic of parts cooling fans.
reset. Clean the ventilation filter
(see section 6.2 page 32).
Cooking Check the connection to water
cycle block; pipeline and make sure the shut-
automatic off valve is open.
reset.
Cooking cycle Cut off the power and power
block. again. If the problem persists,
contact the support center.
Cooking cycle Press M for 1 second.
block.
Cooking cycle Replace the moisture control probe
block. 4
Cooking cycle Replace the moisture control probe
block. 5
COMBIFIT installation, use and maintenance manual