Electrical Connection - Angelo Po COMBIFIT CF623E Manuel D'installation, D'utilisation Et De Maintenance

1.5. Electrical connection
The electrical system shall be fitted with an efficient earthing system,
as required by the regulations in force. You can ensure the electrical
safety of the appliance only in the presence of a compliant electrical
system.
Before wiring, check the voltage and frequency of the power grid
to ensure that they comply with appliance rated values given on the
technical data plate (fig. 6).
For direct connection to the mains, you should placed between the
appliance and the network a device, sized according to the load, which
ensures disconnection.
Its contacts should have a
minimum opening distance
that enables
disconnection
conditions of
category III, according to
installation rules; this device
should also be located so
that it can be easily used by
the operator at any time.
Turn the master switch, to
which the power plug will
be connected, to position 0
(zero). Make the socket cable
section checked by qualified
staff to make sure it suits
the the power absorbed by
the device.
You need to open the top
compartment by loosening
the fastening screws (fig. 7)
and connect the appropriate
cable to the power terminal
block. Refer to the table on
the next page (tab. 1).
To make the electrical con-
nection refer to the wiring
diagrams annexed to this
manual.
Insert the power cord into
the hole of the cable gland
located on the left bottom
side of the oven.
Connect the cable to the
terminal block following the
instructions given in tab. 1.
COMBIFIT installation, use and maintenance manual
MOD
complete
under the
POWER SUPPLY
overvoltage
TOT POWER kW
KXXXXX
NR
400V 3N 50 Hz
OVEN POWER kW
7,9
XXXXXX/XX/XX
6,6
IP
Fig. 6
fig. 7
9