Preliminary Information - Angelo Po COMBIFIT CF623E Manuel D'installation, D'utilisation Et De Maintenance

T2: START/STOP KEY
it enables starting and stopping the cooking cycle. This key can
be:
o :
n
o :
ff
f :
LAshing
T3: ESC KEY:
it allows the user to return to the previous page.
T4: MENU KEY:
it enables the user to return to the main menu.
T5: LIGHTING KEY:
to turn on the lighting system in the cooking chamber.
TS: TOUCH SCREEN:
touch screen. The operating parameters of the appliance are set
and displayed on this screen.
M: DIAL WITH ENCODER:
The dial is used to set the values on the screen. If the dial is
pressed, the value entered is confirmed.
2.2. Preliminary information
The appliance was designed to cook food indoors and should only be
used for this function: any other use should be avoided as it is consid-
ered improper and dangerous.
During operation, supervise the appliance.
Before cooking, run a pre-heating cycle for the oven at a temperature
of about +30 ° / +40 ° C higher than necessary.
The "touch-screen" fitted on the oven provides quick and intuitive ac-
cess to all functions. The parameters and settings of each function can
be set by choosing the function on the display, selecting the desired
value by turning the dial Mand confirming this value by pressing the
button or the dial M. By pressing the dial M you can silence the alarms.
When switched on, the display shows the main menu where you can
choose between
The control panel of the oven is equipped with a single dial M (fig. 9)
to insert or modify the operating parameters of the appliance. This knob
can also be pressed to select a function or confirm a certain parameter.
The dial acts upon a digital encoder and, therefore, it has a continuous
rotation (there is no limit switch). The parameters set via the encoder
vary: clockwise (increase) or counterclockwise (decrease).
At this point the oven is ready for use, in "stand-by" mode, waiting for
user input.
The lighting time inside the cooking chamber varies depending on the
value set (see section 5.3. Page 32). If the oven's door is opened, the
COMBIFIT installation, use and maintenance manual
cooking in progress;
cooking not in progress or stopped;
cooking is in waiting state (door open, error
messages or confirmation of operations).
,
mAnuAL cooking recipes
, .
service
13