General Conditions Of Use; Operator Position - Mondolfo Ferro MT 3600 up Manuel D'utilisation

GENERAL CONDITIONS OF USE

The equipment is intended for professional use only.
CAUTION
Only one operator at a time can work with the machine.
The wheel balancers described in this manual must be used exclusively to measure the
extent and position of car wheel unbalances, within the limits specified in the Technical
specification section.
CAUTION
Any use of the machine other than the described use is to be considered as improper
and unreasonable.
WARNING
Do not start the machine without the wheel locking equipment.
WARNING
Do not clean or wash the wheels mounted on the machine with compressed air or
jets of water.
CAUTION
When working, never use equipment not manufactured by the manufacturer.
CAUTION
Get to know your machine: The best way to prevent accidents and obtain top perfor-
mance from the machine is to ensure that all operators know how the machine works.
Learn the function and location of all the controls.
Carefully check that all controls on the machine are working properly.
To prevent accidents and personal injury, all the equipment must be correctly installed,
correctly operated and correctly serviced.
The following figure shows the positions occupied
by the operator during the various work phases:
A Assembling / disassembling, launching, dimension
detection (where foreseen) and wheel balancing
operations
B Machine program selection
In this way, the operator is able to perform, monitor
and check the outcome of each wheel balancing and
intervene in case of unforeseen events.
80

OPERATOR POSITION

Operator's manual MT 3600 - MT 3600 C Up