Static Balancing - Mondolfo Ferro MT 3600 up Manuel D'utilisation

Proceed as follows to balance motorcycle wheels dynamically using adhesive weights:
- follow the instructions for mounting the motorcycle adapter described in the MOTOR-
CYCLE DYNAMIC PROGRAMME;
- follow the instructions above for the "Motorcycle Dynamic" programme;
- perform a spin;
- at the end of the spin, select the Balancing programme icon
ENTER button until the required programme is selected;
- for the application of the adhesive weight, always use 12 o'clock as a reference regardless
of the setting in Configuration of Adhesive Weight Application Position.
Best results can be achieved if the adhesive weights are positioned with the outer edge
being flush with the rim edge.
Some rims have spokes so wide that it is not possible to place adhesive weights next to
them; a programme which divides the counterweights into two parts has been introduced
to solve this problem.
In this case, when the centred position is reached and it becomes obvious that the balanc-
ing weight will have to be applied in line with a spoke, proceed as follows:
- remain in the centred position;
- select the
grammes" icon);
- select the spoke dimension on the displayed window using the keypad: small, medium,
large or OFF (selection deactivated);
- confirm by pressing the Enter button
- apply two new counterweights in the positions indicated.
The weight division operations can be performed on both balancing sides.
A wheel can be balanced using a single counterweight on one of its two sides or in the centre
of the well. in this case, the wheel is balanced statically. However, there is still the risk of
dynamic unbalance, which becomes more significant as the width of the wheel increases.
Proceed as follows to balance motorcycle or car wheels statically:
- perform a spin;
- at the end of the spin, select the Balancing programme icon
ENTER button until the required programme is selected;
The displayed image now shows only one position search.
- Apply the balancing weight at 6 o'clock through the LASER line or at 12 o'clock (see
Operator's manual MT 3600 - MT 3600 C Up
Motorcycle ALU programme
Split Weight Programme
Divide side weight icon (displayed instead of the "select ALU pro-

Static balancing

;
and press the
and press the
101