Mondolfo Ferro MT 3600 up Manuel D'utilisation page 83

Wheel release
- Press the control pedal for at least one second to release the wheel from the flange.
Centring with flanges
Removing the C hub
- Insert the special C key (supplied with the machine) in the slot of the C hub (fig.11b);
- Completely unscrew the C hub;
- Mount the flange on the shaft and lock it in place with the two screws (A, fig.11c) using
the CH 6 wrench.
- Lock the wheel onto the flange as usual.
Assembling the C hub
To reassemble the C hub, proceed as follows:
- Press and hold the keyboard button
and bring to the open position the pneumatic cylinder of the lock device C; The mes-
sage A52 will be displayed on the monitor.
- insert the split pin (supplied with the machine) in the cylindrical protection bush (B,
fig.11d)
Operator's manual MT 3600 - MT 3600 C Up
A
11b
11c
for 3 seconds to lock the shaft rotates
83