Mondolfo Ferro MT 3600 up Manuel D'utilisation page 73

the minimum distances indicated in figure 7
are maintained between the machine and any
surrounding walls/obstacles;
- trace the position for drilling on the floor;
- drill in the traced position and then take the
included Fischer M8 and insert them into the
holes that were made;
- anchor the machine to the ground, fastening
the L shaped brackets to the Fischers using the
relative screws and washers (Fig. 8);
- tighten the three fastener screws onto the body.
Main working elements of the machine (Fig. 10)
(A) Automatic diameter and distance measuring arm
(B) Automatic width measuring arm (if present)
(C) Head
(D) LCD monitor
(E) Control keypad
(F) Side flange holder
(G) Weight tray
(H) Wheel support shaft
(I) Handling holes
(L) Control pedals C
Operator's manual MT 3600 - MT 3600 C Up
8
73