Wheel Data Entry - Mondolfo Ferro MT 3600 up Manuel D'utilisation

Wheel data entry for wheel balancers without external
The machine allows for the diameter and distance values to be entered automatically;
the width value can be entered using the keypad.
- Bring the automatic measuring arm into contact with the inner side of the rim (Fig.12).
Take great care to position the arm correctly so as to ensure accurate data reading.
- Keep the arm in contact with the rim until the machine has acquired the wheel's diam-
eter and distance values. The following screen appears during this phase:
- if only one measurement is taken, the machine interprets the presence of a rim with
balancing using a clip weight on both sides (Dynamic Balancing Programme);
- moving the arm to the rest position, the machine will set up for the manual WIDTH entry;
- in this phase, it is possible to perform an additional acquisition of the rim diameter and
distance.
- Measure the width of the rim using the provided calliper (Fig. 13).
86

WHEEL DATA ENTRY

mechanical sensor
12
Operator's manual MT 3600 - MT 3600 C Up