Mondolfo Ferro MT 3600 up Manuel D'utilisation page 119

A 31 Optimisation procedure (OPT) already launched by another user.
A 41
Contact the technical support centre.
A 52 Initiated the procedure for assembly of the hub of auto wheel locking system.
After 60 seconds, the procedure ends automatically.
A Stp Wheel stop during the spin phase.
Wheel movement is not integral with swinging unit movement: Check correct
wheel tightening.
A Cr Contact the technical support centre.
E 1 Absence of sensitivity calibration.
Perform the sensitivity calibration procedure.
E 2 Error condition during sensitivity calibration.
Repeat sensitivity calibration paying attention to the first spin, which must be
performed with the wheel as in the successive spins.
Take particular care NOT to knock the machine during calibration.
E 3 I/E 2/3 Error condition at the end of sensitivity calibration. Repeat the calibration, if
the message persists perform the following checks:
• Correct sensitivity calibration procedure;
• Correct fastening and position of the calibration weight;
• Mechanical and geometric condition of the calibration weight;
• Geometry of the wheel used.
E 4 a) External mechanical sensor calibration error.
Calibrate the external mechanical sensor.
b) if the error continues after calibrating the external mechanical sensor or
the external mechanical sensor is not present, or there is a distance-diameter
measuring sensor fault, call the technical support centre.
E 6 Error condition when executing optimisation programme.
Repeat the procedure from the beginning.
a) Mechanical width sensor not in the rest position when machine was switched
E 12
on. Switch off the machine, return the sensor to the correct position and switch
back on. If the error persists, contact the technical support centre.
b) External mechanical sensor not present or faulty. Visualisation of this error
can be disabled by performing the following procedure:
- Select the External MECHANICAL sensor calibration icon and press ENTER
E 27 Excessive braking time. If the problem persists, call in the technical support
centre.
E 28 Encoder counting error. If the error occurs frequently, call in the technical sup-
port centre.
E 30 Wheel spin device failure. Switch off the machine and call in the technical sup-
port centre.
E 32 The wheel balancer has been jolted during the reading phase. Repeat the spin.
E F0 Error reading 0 notch.
CCC CCC Unbalance values greater than 999 grams.
Operator's manual MT 3600 - MT 3600 C Up
– E – Error messages
.
119