Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

This program is used to optimise the synchronisation of the LCD motor approved by the
manufacturer. Proceed as follows to perform this synchronisation:
- select the
- once selected, the following screen will appear on the monitor;
- to perform the synchronisation, press the corresponding key directly on the LCD monitor
(read the instructions in the monitor user manual).
Push the exit key
IMPORTANT:
repeat the operation if necessary if synchronisation was not successful.
The machine can recognise a certain number of malfunction conditions and signals them
by displaying the relevant messages.
A 3
Wheel not suitable for performing the sensitivity calibration, use a wheel of
average dimensions (typically 5.5"X14") or larger, but NOT exceeding a weight
of 40kg.
A 5
Incorrect dimension settings for an ALU programme. Correct the set dimensions.
A 7
The machine is temporarily unable to select the requested programme.
Perform a wheel spin, then repeat the request.
A 20
Sensor in an incorrect position during calibration.
Bring it to the position indicated and repeat the calibration.
A 26
Programme available only after selecting one of the following programmes:
EASY ALU1 / EASY ALU2 / Motorcycle Dynamic / Motorcycle ALU or if selected
in the Motorcycle Programme but with the wheel NOT in the centred position.
118
Monitor Auto Setting
MONITOR AUTO SETTING icon;
to exit the program without performing the synchronisation.

ERROR MESSAGES

– A – Notice Messages
Operator's manual MT 3600 - MT 3600 C Up

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mt 3600 c up

Table des Matières