Mondolfo Ferro MT 3600 up Manuel D'utilisation page 96

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

(available on with EASY ALU programme)
This programme divides the outer weight Pe into two weights, P1 and P2, located in any
position chosen by the operator.
The only condition is that the two weights and the original outer weight Pe must be within
an angle of 120°, as shown in Fig. 19.
Figure 19. Conditions necessary for using the Hidden weights programme
The Hidden Weight programme is used on alloy rims, only and exclusively in conjunction
with the EASY ALU1/EASY ALU2 programme:
- when you would rather hide the outer weight behind two spokes for aesthetic reasons.
To use this programme, proceed as follows:
1. Beforehand, select between one of the programmes, EASY ALU1, EASY ALU2 by select-
ing the EASY ALU1 Balancing programme or the EASY ALU2 Balancing programme icon.
The mask for measuring the unbalance on alloy rims is displayed.
2. Perform the wheel balancing with the procedure described in the "EASY ALU1, EASY
ALU2 Programme" chapter, without however applying the outer weight.
3. Select the
machine displays the message shown in Fig. 19a on the screen.
96
"HIDDEN WEIGHTS" PROGRAMME
Hidden Weight icon. If the wheel is balanced on the outer side, the
Figure 19a. Hidden Weights: procedure error
Pe not between P1 and P2
19a
Operator's manual MT 3600 - MT 3600 C Up
19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mt 3600 c up

Table des Matières